Renvations Team
A cold shower on a hot Sunday morning is a very pleasant sensation that cannot be expressed in words. If you don’t have it in your bathroom, then you are missing out on something very important. Some old houses don’t have them, and adding one is a very easy process; however, the difficult part is adding the drain. Adding a shower drain is a very difficult task, especially when you have a concrete floor. This article will give you a method to add a chute to your bathroom. So, read the article till the end to learn how to install a shower drain in concrete floor?
Tools and Materials Required
Before you begin working, it is important that you must have all the important tools. The following tools will help you out with the installation process. So, purchase these items before you start work. You will require:
- Shower Drain Kit
- PVC Cement
- Measuring Tape
- Pencil
- Hacksaw
- Screwdriver
- Hole Saw
- Hammer
- Chisel
- Level
- Silicone Sealant
Purchase these items from any shop near you.
Installation Process
After you have all the tools, you can begin the installation process as provided below:
1. Prepare the Concrete Floor
Before you begin the installation process, you need to prepare the concrete floor. Start by removing the old one if you have one. Next, clean the area around the hole and remove any debris or dirt. You also need to ensure that the floor is level and free from any cracks.
2. Measure the Pipe
Once you have prepared the floor, measure the diameter of the pipe. This will help you choose the right size of the tube. Mark the center of the outflow pipe on the floor using a pencil and then move to the next step.
3. Cut the Hole
Use a hole saw and cut a hole in the floor at the center of the pipe. If you don’t have a hole saw, you can use a hammer and chisel to create a hole. Ensure that the hole is slightly larger than the outflow pipe to allow for proper fitting.
4. Installation
Insert the drain into the hole and ensure that it is level. Secure the drain in place using screws and a screwdriver. Apply PVC cement around the drain to create a watertight seal.
5. Connect with the Tube
Connect it to the shower channel using PVC cement. Ensure that the connection is tight and secure.
6. Test the Drain
Run water through the shower chute to test its functionality. Check for leaks and ensure that the water flows smoothly into the drain.
7. Apply Silicone Sealant
Once you have confirmed that the shower channel is working correctly, apply silicone sealant around the edges of the drain to create a watertight seal.
Conclusion
Installing it on a floor may seem like a difficult task, but with the right tools and materials, it can be done without professional help. By following the method given in this article, you can install a shower channel on your floor and ensure that your shower functions correctly. Remember to test the channel and check for leaks before applying silicone sealant to ensure that the shower is watertight.
